WALL RECOVERING WITH PORCELAIN TILES

Sticky Plaster Process
Seating tiles

Mark the tile location with vertical and horizontal lines to ensure the plum and level of the tiles. On the wall, mark the length and width of one tile.

Adjust the level, using the lines as guides, and move from left to right and top to bottom.

With the smooth side of a metal trowel, apply a layer of sticky plaster.

Immediately afterward, use the grooved edge of the trowel to even the thickness of the plaster to 5 mm.

Place the tile on the flat, horizontal, dry surface with the paper side facing down.

With a trowel, fill in the tile joints with rejoining material, keeping a uniform thickness of 2mm to 3mm.

Apply the tile to the sticky plaster, pressing lightly with your hands.

Tap lightly on the tile using a piece of wood and a rubber mallet.

During installation, make sure the plaster is still moist by touching it lightly with your fingers. If the plaster becomes dry, remove it and apply fresh material.

CUIDADOS:
- The tiles should be placed while observing the pattern of previously installed tiles. Maintain a constant gap between tiles.
-Do not use joining material that has already dried.

- Prepare surface for tile
- Prepare sticky plaster
- Prepare nata of tiles
- Install tiles
- Remove paper and glue
- Adjustment
- Cut tile plates
- Final clean-up

Return to index